24
EN
Initial Setting
When you turn on this unit for the first time, you need
to follow these steps.
1 Press [B ON/STANDBY].
2 Turn the TV on. Select the input to
which the unit is connected.
3 Select your desired channel preset
type using [U \ D]. Then press
[ENTER/OK].
The unit will start getting channels available in
your area.
Digital tuning:
Only the DVB channels receivable in your area
are automatically scanned and memorised.
Digital & Analog tuning:
Both analogue and DVB channels receivable in
your area are scanned and memorised
automatically.
Analog tuning:
Only the analogue channels receivable in your
area are automatically scanned and memorised.
4 After finished channel setting,
“Clock Setting” will appear. Then
press [ENTER/OK].
• If you want to adjust the clock, follow to step 4
on page 32 in “Manual Clock Setting”.
5 Press [ENTER/OK] to exit.
Channel Setting
You can retune this unit or edit the channel setting
with following methods.
Auto Tuning (DVB & ANALOG)
Programme the tuner to scan both analogue and DVB
channels you can receive in your area.
1 In stop mode, press [SETUP]. Select
“General Setting” using [U \ D],
then press [ENTER/OK].
General Setting menu will appear.
2 Select “Channel” using [U \ D],
then press [ENTER/OK].
3 Select “Auto Tuning (DVB &
ANALOG)” using [U \ D], then press
[ENTER/OK].
The unit will start storing channels available in
your area.
Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel
901-999 after it is scanned by this unit.
4 Press [SETUP] to exit.
You can select the channels memorised only in
this unit by using [PROG. G / H].
To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when DVD is in any
recording mode (normal recording, One-touch Timer
Recording or timer recording).
Basic Setup
Initial Setting
Auto Tuning
Make sure the antenna is
connected to “ANTENNA IN” jack.
Digital tuning
Digital & Analog tuning
Analog tuning
Initial Setting
Clock Setting
01 / 01 / 2007 (MON)
10:00
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All
Auto Tuning (DVB & ANALOG)
DVB Channel Setup
ANALOG Channel Setup
E2J70BD_EN.book Page 24 Friday, June 29, 2007 2:50 PM
To Next Page
Loading...
