EasyManua.ls Logo

Toshiba RD-97DTKB - Basic Recording

Toshiba RD-97DTKB
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
Basic Recording
Follow the steps below to record a TV programme.
1 Press [B ON/STANDBY] to turn on
the unit.
Turn on the TV and be sure to select the input to
which the unit is connected.
If you are recording to the HDD, press [HDD],
then proceed to step
5.
If you are recording to a disc, press [DVD].
2 Press [OPEN/CLOSE A] to open the
disc tray.
3 Place the disc on the disc tray with
its label facing up. Be sure to align
the disc with the disc tray guide.
4 Press [OPEN/CLOSE A] to close the
disc tray.
5 Select the recording mode using
[REC MODE]. (See page 33.)
6 Press [INPUT SELECT F] to select
DVB, analogue or external input
mode, then select the desired
channel to record using
[PROG. G / H] or
[the Number buttons].
7 Press [REC I] to start recording.
The “I HDD” or “I DVD” mark will be displayed
on the TV screen for 5 seconds.
To pause the recording, press [PAUSE F]. Press
[PAUSE F] or [REC I] again to restart the
recording.
8 Press [STOP C] to stop the
recording.
This operation may take a few moments to
complete.
Hint
You can change the channel while in the REC pause
mode.
Note
Recording starts immediately and continues until the
disc is full or you stop recording.
You cannot change the recording mode in the REC
or REC pause mode.
If you want to monitor the programme that you are
recording, make sure the device such as a Satellite
Box is turned off or press [DISPLAY] when it is
connected to AV2.
You can play back a title on one component while
making a recording on other. To do so, simply select
the component (HDD or DVD) you wish to use for
the playback by pressing [HDD] or [DVD] during
HDD / DVD recording. And then follow the normal
playback procedure.
If playback and recording are in progress at the
same time, select the appropriate component by
pressing [HDD] or [DVD] before you press
[PAUSE F] or [STOP C] to pause or stop the
operation.
NTSC recording is prohibited in this unit.
HDDHDD
D
D
VD-R
VD-R
W
W
DVD-RW
Video
DVD-RWDVD-RW
VR
DVD-RDVD-R
D
D
VD+R
VD+R
W
W
DVD+RW D
D
VD+R
VD+R
DVD+R
Disc tray guide
E2J70BD_EN.book Page 39 Friday, June 29, 2007 2:50 PM

Related product manuals