Toshiba RD-97DTKB - TV View Operation

29
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
TV View Operation
The following operations are available while viewing
TV channels through this unit’s tuner.
Selecting the Audio Mode
You can switch between TV audio modes by pressing
[AUDIO D] on the remote control. Each mode is
indicated on the TV screen.
• During reception of analogue bilingual broadcasts
• During the reception of DVB broadcast, when you
press [AUDIO D], sound track display will appear.
Press [AUDIO D] repeatedly to change the sound
track.
• If the programme does not have more than one
sound track, [AUDIO D] is not effective.
Selecting the TV Aspect Ratio
You can select the TV aspect ratio to match the format
of the programme you are playing back with the unit
and that of your TV screen (4:3 standard or 16:9 wide
screen TV).
1 In stop mode, press [SETUP]. Select
“General Setting” using [U \ D],
then press [ENTER/OK].
2 Select “Video” using [U \ D], then
press [ENTER/OK].
3 Select “TV Aspect” using [U \ D],
then press [ENTER/OK].
4 Select the desired option using
[U \ D], then press [ENTER/OK].
5 Press [SETUP] to exit.
Hint
If you have a standard TV:
• Select “4:3 Letter Box” for a full width picture
with black bars at the top and bottom.
• Select “4:3 Pan & Scan” for a full height picture
with both sides trimmed.
If you have a wide screen TV:
• Select “16:9 Wide”.
Digital Teletext Reception
Many broadcasters provide a DVB Teletext service in
the form of a dedicated Teletext channel. This Digital
service includes high quality text and graphics along
with advanced navigation options.
• Make sure “Service Preference” is set to “Data
Service” (See page 31.)
1 Press [TEXT] to display Teletext
screen.
• Teletext for the TV channel you have selected
will be displayed.
2 Use [RED] / [GREEN] / [YELLOW] /
[BLUE] to follow the instructions on
screen.
3 Press [TEXT] to switch the Teletext
display off.
Note
• To use DVB Teletext, you must set “Service
Preference” to “Data Service”. (See page 31.)
• To set the Teletext language, refer to “Language
Setting” on page 31.
EPG (Electronic Programme Guide)
Electronic programme guide (EPG) gives you a list of
the DVB programmes and detailed information about
the programmes. To call up EPG (Electronic
Programme Guide) while viewing DVB/analogue
channel or external input (AV1/AV2/AV3), press
[GUIDE]. You can also call up EPG by following steps.
1 In stop mode, press [SETUP]. Select
“Timer Programming” using [U \ D],
then press [ENTER/OK].
2 Select “EPG” using [U \ D], then
press [ENTER/OK].
• Select the TV programme using [U \ D ], then
press the [ENTER/OK] to watch the selected
channel or press [BLUE] to display time
schedule of the DVB channel.
• From the EPG screen, you can also set the
timer recording. Refer to “Timer Recording
(EPG)” on page 45.
Mode Audio output
Display on
the TV screen
Main Main audio from both speakers Main
Sub Sub audio from both speakers Sub
Main /
Sub
• Main audio from the left speaker
• Sub audio from the right speaker
Main / Sub
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All
TV Aspect
Select Video
Video Out
TV Aspect
4:3 Letter Box
4:3 Pan & Scan
16:9 Wide
DVB
DVB
3_BasicSetup_EN.fm Page 29 Friday, July 13, 2007 4:49 PM