83
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
5. Subtitle Language (Default: OFF)
(DVD only)
Set the Subtitle language.
Select a setting using [U \ D], then
press [ENTER/OK].
Your setting is activated.
If “Other” is selected, enter the
appropriate 4-digit code using
[the Number buttons].
Refer to “Language Code” on page 93.
When you finish entering the code,
press [ENTER/OK].
Hint
• You can also change or switch off the subtitles on a
DVD from the disc menu if it is available.
•Press [CLEAR] or [L] to erase numbers entered
incorrectly.
Note
• You can only select the languages supported by the
inserted disc.
• The Audio Language setting may not be available for
some discs.
6. Angle Icon (Default: ON) (DVD only)
Set the angle icon.
Select a setting using [U \ D], then
press [ENTER/OK].
Your setting is activated.
7. Still Mode (Default : Auto) (DVD only)
Select a setting using [U \ D], then
press [ENTER/OK].
Your setting is activated.
Note
• An individual picture on TV screen is called as
Frame, which consists of two separate images
called as Field. Some pictures may be blurred at the
“Auto” setting in still mode due to their data
characteristics.
8. Variable Skip / Replay
Assign [VARIABLE SKIP] or
[VARIABLE REPLAY] to skip or rewind by a
certain amount of time when they are pressed.
Select a desired item using [U \ D], then
press [ENTER/OK].
Refer to the explanations below and set the
selected item.
A : Variable Skip (Default: 30 seconds)
Sets the amount of skip time for
[VARIABLE SKIP].
B : Variable Replay (Default: 30 seconds)
Sets the amount of rewind time for
[VARIABLE REPLAY].
9. TV System (Default : PAL) (DVD only)
Select a setting using [U \ D], then press
[ENTER/OK].
Your setting will be activated.
Note
• With discs recorded using the PAL system, a PAL
signal is output for viewing on a PAL system TV.
• Discs recorded with the PAL system cannot be
viewed on an NTSC system TV.
• With discs recorded using the NTSC system, an
NTSC signal is output for viewing on an NTSC or
Multi system TV.
• With discs recorded using the NTSC system, select
PAL to view on a PAL system TV.
Auto: Automatically select the best resolution
setting (“Frame” or “Field”) based on the
data characteristics of the pictures.
Field: Select “Field” when the pictures are still
unstable even if “Auto” is selected. “Field”
stabilises the pictures, although the picture
quality may become coarse due to the
limited amount of data.
Subtitle Language
OFF
English
Other
Code Input
----
Angle Icon
ON
OFF
Still Mode
Auto
Field
Frame
Frame: Select “Frame” to display relatively
motionless pictures in higher resolution.
“Frame” improves the picture quality,
although it may unstabilise the pictures
due to simultaneous output of two Field
data.
PAL: Outputs a modified PAL signal for viewing
discs recorded with the NTSC system on a
PAL system TV.
Auto: Changes the video system (PAL / NTSC)
automatically according to the format of
the inserted disc.
Variable Skip
Variable Replay
Variable Skip / Replay
A
B
Variable Skip
5 seconds
15 seconds
30 seconds
1 minute
5 minutes
5 seconds
15 seconds
30 seconds
1 minute
5 minutes
Variable Replay
TV System
PAL
Auto
E2J70BD_EN.book Page 83 Friday, June 29, 2007 2:50 PM
To Next Page
Loading...
