18 RemotEye II User Manual – 50024-014
Installing RemotEye II/External
Follow these steps to install the RemotEye II/External device.
1. Insert the power adapter cable of the RemotEye II into the 12 VDC power receptacle of the
RemotEye II device.
2. Plug the RemotEye II power adapter into a 120/220 VAC power source. For best results, be
sure outlet is powered by a Toshiba UPS.
3. Connect the UPS cable from the RS232 serial port of the Toshiba UPS to the RemotEye
II/External UPS port.(See Figure 2: RemotEye II/External)
Figure 2: RemotEye II/External
To Next Page
Loading...
