40 RemotEye II User Manual – 50024-014
Connecting to the RemotEye II via Telnet
A telnet configuration session can be established once the hardware and software are prepared. Follow
these steps to begin configuration:
1. Type telnet followed by the IP address of RemotEye II at a Unix console or a DOS prompt.
2. Press [Enter].
3. Key in the password (default is public) when prompted.
For more information on using telnet, please refer to telnet application Windows help.
The RemotEye II will only accept 2 telnet clients simultaneously. The telnet connection will time-out after
60 seconds of inactivity.
RemotEye II Telnet Menu Navigation
The configuration menus for telnet configuration are identical to those presented by a direct configuration
session. Refer to page 25 for detailed guidance through configuration menus of RemotEye II.
To Next Page
Loading...
