Toshiba RemotEye II - Connecting to the Remoteye II Via Terminal

RemotEye II User Manual – 50024-014 23
Connecting to the RemotEye II via Terminal
A direct configuration session can easily be established once the hardware and software are properly set
up. Follow these steps to begin configuration:
Terminal Emulator Example
To configure the RemotEye II from a Windows platform, use HyperTerminal. (Except Windows Vista.
Hyper Terminal is not available with Windows Vista. Hyper Terminal software is available through various
sources on the Internet. Contact Toshiba for additional information.)
HyperTerminal is a standard terminal emulator packaged with all Windows operating systems except
Vista. Launch the HyperTerminal program by navigating to Start → Programs → Accessories →
HyperTerminal → HyperTerminal, and follow the prompts.
Enter a name and select an icon for the application at the Connection Dialog box.
Select a direct connection to an appropriate com port listed in the pull-down menu.
Ensure that the Properties dialog box is setup according to preceding .
Baud Rate — 9600
Data Bits — 8
Parity — None
Stop Bits — 1
Flow Control —- None
Press [Enter] and the RemotEye II version and Password field will be displayed (see
Figure 3: Console Login Screen).
Enter the password (default is “public”) and press [Enter] to display the RemotEye II Main Menu.
+====================================================================+
| [ TIC RemotEye II Login Menu ] |
+====================================================================+
Enter Password: ******
Figure 3: Console Login Screen