22 RemotEye II User Manual – 50024-014
Configuring the RemotEye II via Terminal
The RemotEye II can be configured by directly connecting to the device.
Hardware Setup
Direct configuration is accomplished through the provided cable. Follow these steps to setup the
hardware for direct RemotEye II configuration:
Connect the DB9 female end of the PC cable to the terminal or workstation COM port.
Connect the RJ45 end of the PC cable to the PC port of RemotEye II/External or the COM port of the
RemotEye II/Internal.
Software Setup
The direct configuration is accomplished by using the RS232 communication protocol. The direct
communication can be performed from a workstation running Terminal Emulator Software (TES)
To Next Page
Loading...
