RemotEye II User Manual – 50024-014 39
Routing to the RemotEye II
If the workstation is not on the same network as the RemotEye II, the system may require the addition of
a network route. This is typically only necessary when RemotEye II is using its default address.
Consult operating system documentation pertaining to the addition of network routes for instruction.
Example Route Addition
Windows operating systems provide the command Route Add for adding network routes.
Assume the default IP Address of the RemotEye II is 172.18.1.63, and assume the IP Address of the
workstation is 210.67.192.147. To add the appropriate network route between these two devices, follow
these steps:
Turn on the workstation, and setup the TCP/IP protocol (if necessary).
Enter the following command to add a routing condition:
Route add 172.18.1.63 210.67.192.147
See the Windows manual for further information on how to add a routing condition to a workstation.
To Next Page
Loading...
