Toshiba Satellite C800 - 4.3 HDD

Replacement Procedures
Satellite C800 and Satellite L800 Maintenance Manual (960-Q08) 10
4.3 HDD
Removing HDD-H9.5mm
The following describes the procedure for removing the HDD (See Figure 4-3-1 to 4-3-3).
CAUTION: Take care not to press on the top or bottom of a HDD. Pressure may cause
data loss or damage to the device.
1. Turn the computer upside down.
2. Remove the battery.
3. Loosen the following screws securing HDD Door and then remove the door.
 M2.54.0B FLAT BIND screw x2
4. Remove the following screws securing the HDD assembly and ODD
 M23.0B FLAT BIND screw x2
5. Remove ODD and then disconnect the HDD assembly from the connector on the
system board.
Figure 4-3-1 Remove HDD Door