Toshiba Satellite C800 - Touch Pad

Replacement Procedures
Satellite C800 and Satellite L800 Maintenance Manual (960-Q08)
30
4.10 Touch pad
Removing the touch pad
The following describes the procedure for removing the touch pad (See Figure 4-10-1 to 4-
10-2).
1. Peel off the protect Mylar and disconnect the button FFC from the connector on the
touch pad. (Figure 4-10-1)
2. Remove the following screws securing the button bracket.
 M2.03.0 Flat BIND screws x2
3. Remove the following screws securing the button board.
 M2.03.0 Flat BIND screws x3
4. Remove the bracket from the top cover assembly following the arrows. (Figure 4-10-
2)
5. Peel off the touch pad from the top assembly.
Figure 4-10-1 Remove the touch FFC and screws