Replacement Procedures
Satellite C800 and Satellite L800
Maintenance Manual (960-Q08) 13
4.4 Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-4-
1and 4-4-2).
1. Remove the HDD Door.
2. Remove the following screws securing an optical disk drive.
M23.0B FLAT BIND screw x1
3. Disconnect an optical disk drive toward the arrow direction.
Figure 4-4-1 Remove an optical disk drive
4. Remove screws securing side bracket.
M23.0B FLAT BIND screw x2
To Next Page
Loading...
