Replacement Procedures
Satellite C800 and Satellite L800
Maintenance Manual (960-Q08)
The following describes the procedure for installing the display assembly.
1. Put top assembly on display assembly and turn the hinge bracket to make the top boss
insert into hinge bracket hole.
2. Put LCD cable in the right place and put MB on the top. ( Figure 4-8-4)
Figure 4-8-4 LCD cable routing
3. Secure the hinges with the following screws.
M2.56.5 FLAT BIND screw x4
4. Secure the system board with the following screws.
M2.53 FLAT BIND screw x3
5. Put the wireless LAN antenna cable on the right location from the guide.
6. Put the base on the top and secure the base with the following screws.
M2.5. x 6.5B BIND screw x11
M2. x 3.0B BIND screw x3
M2.5. x 3.0B BIND screw x1
To Next Page
Loading...
