Replacement Procedures
Satellite C800 and Satellite L800
Maintenance Manual (960-Q08)
The following describes the procedure for installing the LCD unit.
1. Install the LCD hinge to the LCD and secure them with the following screws.
M2.03 BINK screw x4
2. Connect the LCD cable to the connector on the back of LCD.
3. Stick the conductive tape on the connector of LCD cable.
4. Secure the LCD unit with the following screws.
M2.5x4.0 screw x2
5. Connect LCD cable to the connector of the camera.
6. Install the display mask.
7. Secure the display mask with following screws
M2.55 screw X4
8. Cover screws with Screw MYLAR X4
NOTE: When installing the display mask, make sure there is no gap between the display
mask and the display cover.
To Next Page
Loading...
