2 Troubleshooting Procedures
Satellite C800 and Satellite L800
Maintenance Manual (960-Q08)
Procedure 3 Format Check
The computer’s HDD is formatted using the Free -DOS FORMAT program or the physical
format program of the test program. To format the HDD, start with Check 1 below and
perform the other steps as required.
Refer to the Free -DOS Manual for the operation of Free -DOS. For the format by the test
program, refer to the Chapter 3.
Check 1 Format a 2.5” HDD using Free -DOS FORMAT command. Type as FORMAT
C:/S/U.
If 2.5” HDD can not be formatted, perform Check 2.
Check 2 Using the Free -DOS FDISK command, set the 2.5” HDD partition. If the
partition is not set, go to Check 3. If it is set, format 2.5” HDD using Free -DOS
FORMAT command.
Check 3 Using the Diagnostic Disk, format 2.5” HDD with a format option (physical
format). If HDD is formatted, set the 2.5” HDD partition using Free -DOS FDISK
command.
If you cannot format 2.5” HDD using the Tests and Diagnostic program, go to
Procedure 4.
To Next Page
Loading...
