Toshiba Satellite C855D - Bridge Media; Removing the Bridge Media

4 Replacement Procedures 4.2 Battery Pack/Bridge Media
4-10 Satellit /Satellite Pro /C850D/C855D /L850D/L855D Maintenance Manual
4.2.2 Bridge Media
Removing the Bridge Media
Remove the Bridge Media according to the following procedures and Figure 4-2, after
checking that the computer is turned off in boot mode.
1. Push a Bridge media. It will pop out partly when you release, so pull out the Bridge
media.
Bridge media
Figure 4-2 Removing the Bridge Media
Installing the Bridge Media
Install the Bridge Media according to the following procedures and Figure 4-2, after checking
that the computer is turned off in boot mode.
1. Insert a Bridge media and press it until it is securely connected.
After the Bridge media is installed, check the hardware configuration in the Hardware Setup
or TSETUP program to make sure that the Bridge media is compatible with the current
hardware configuration.