Toshiba Satellite C855D - LED Module; Removing the LED Module

4.14 LED Module 4 Replacement Procedures
Satellit /Satellite Pro /C850D/C855D /L850D/L855D Maintenance Manual 4-37
4.14 LED Module
NOTE: ICs are fragile. Use extreme care not to apply pressure to the ICs along the edges
of the LED module.
NOTE: Dispose of used LED panels (fluorescent (FL) tubes) as required by local
ordinances or regulations.
NOTE: The LED cable must be carefully peeled away before disconnecting it from the
module.
Removing the LED module
Remove the LED module according to the following procedures and Figures 4-23, 4-24.
1. Remove two M2.5x4.5 white flat head screws on each side securing the LED hinge.
2. Carefully tilt the LED module toward you.
3. Remove three M2x3 black flat head screws on each securing the LED bracket.
4. Remove the LED brackets.
5. Turn the LED upside down. Be sure to place it on a cushioned surface such as a foam
pad.
6. Remove the tape and LED cable connector. Then disconnect the LED cable.