DKT3000 Settings
Telephone Programming Mode
Strata CTX DKT/IPT Telephone 10/04 101
Telephone Programming Mode
The 3000-series telephones enable you to set a number of features directly from the
phone, including: Call Waiting Tone (On/Off), Flex Key, Msg Key, LCD contrast,
Speakerphone/Microphone Room Noise Sensitivity (On/Off), and Country settings.
“Telephone Programming Mode A” programs settings on a ROM chip inside the
telephone.
Note Some of the procedures use Feature Buttons (FB1, FB2, etc.). When your
telephone is in Programming Mode, the flexible buttons are numbered as
Feature Buttons, as shown at the beginning of this appendix .
³ To place your telephone in Programming Mode
³ Press
++++ROG simultaneously. The LCD displays “DKT PROGRAM
MODE” and “SELECT=”. Your phone will not ring if it receives a call while in
Programming Mode.
³ To exit from Programming Mode
³ Go Off- and On-hook or wait for 30 seconds for Programming Mode to
automatically time out.
Telephone Program Option Reset
This function resets all Programming Mode option settings to their default setting.
1. Press
++++ROG (simultaneously).
2. Press
9RO V + 0VJ (0VJ LED On means reset is set to activate)
3. Press
+ROG to activate reset.
4. Go off-hook, then on-hook to exit the program mode.
To Next Page
Loading...
