Strata CTX DKT/IPT Telephone 10/04 115
Administrator Functions E
This appendix contains some of the functions that can perfomed using Administrator
Mode.
Important! These functions require Strata CTX release 2.22 or higher software.
You can access the Administrator mode using either the DKT2000 or DKT3000 series
telephones. Toshiba recommends using the DKT3020-SD.
To access the Admin mode, the telephone must be enabled for this function in system
programming by the telephone system administrator.
Functions
Using the soft keys on your telephone, you can program the following functions in
Administrator mode:
• Phone Name – enter the Extension (PDN) name for any telephone in the Strata
CTX
• Door Name – enter door phone name
• System SD/Name
1
– enables you to program system speed dial names
• Station SD/Name
1
– enables you to program station speed dial names for any
station in the system
• CO Line Name – program CO line names
• DNIS Name – program DNIS names
1 The Admin telephone mode allows speed dial names to be programmed but the actual speed dial numbers
are programmed using the speed dial programming procedures in this guide.
To Next Page
Loading...
