DKT3000 Settings
DKT2000 Mode On/Off
104 Strata CTX DKT/IPT Telephone 10/04
4. Press +ROG. This sets the LCD lightness/darkness contrast on the middle setting.
5. Go off-hook, then on-hook to exit the program mode.
³ Test the Display on Large LCD Telephones (DKT3014-SDL only)
1. Press
++++ROG (simultaneously).
2. Press
3DJH.
3. Press
. LCD screen is blank.
4. Press
. Each segment shows three vertical lines, in all eight rows.
5. Press
. Each segment contains five short horizontal lines, in all eight rows.
6. Press
. Each segment contains a pattern of small dots, in all eight rows.
7. Press
. All of the available characters, including numbers, display.
8. Go off-hook, then on-hook to exit the program mode.
DKT2000 Mode On/Off
If you have a cordless telephone (DKT2204-CT or DKT2304-CT) that is connected to
a 3000-series telephone, you must place your DKT into 2000-mode before connecting
the cordless telephone; otherwise, the 3000-series telephone will not work.
In 2000-mode:
• Only 16 characters by two lines display on the LCD.
• LCD Feature button does not work
• Spdial button does not work
Turn DKT2000 Mode On/Off
Important! You must change the mode on DKT3000 telephone before connecting a
DKT2204-CT or DKT2304-CT to the DKT3000.
1. On the DKT3000 telephone, press
++++ROG (simultaneously).
2. Press
.
3. Press
)% (or )% on the DKT3014). LED On = 2000 telephone. LED Off =
3000 telephone.
To Next Page
Loading...
