Toshiba Strata DK 16 - Page 291

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-41-
TABLE RM-AK
PROGRAM 78
CO LINE SPECIAL RINGING ASSIGNMENTS-DISA/IMDU/
NIGHT RINGING OVER EXTERNAL PAGE
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 78
P78
Enter Program Number 78
3 P78 1
Press CR.
6 To Exit Program/Store Data
A)
B)
C)
To store data, press CR.
Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
Refer to the System Record Sheet and enter the feature number
for the feature to be programmed.
Example: Feature code 1, enter 1.
4 P78 13Refer to the System Record Sheet and enter the code number
for the area of the feature being programmed.
Example: Code 3, enter 3.
P78 13 01 N
02 N Y
P78 ##
P
P78 13 01 N
02 N Y
Refer to the System Record Sheet and enter the CO line buttons
that will be associated with this feature.
Example: CO button 01, enter 0 1.
The system will designate whether the CO button/LED is on/off.
Refer to the System Record Sheet and change if required.
Press SPACE to display next CO button/LED.
5
NOTE:
Pro
g
ram 79 uses T
y
pe 2 procedure.