Software A3TY07X
Page 4
November, 2019
The display screens available to the user during normal programming and or operation are organized in a
tabular format allowing the user to select between the Main operational data and command tab, a tab
displaying various data points Monitored during operation, and the Programming tab.
3.1 Initialization and Splash screen
The splash screen appears at power up only. While this screen is displayed the MVi-EOI is searching for
the correct baud rate and parity. The MVi-EOI will also initialize the required start-up parameters from the
drive and write the real time to the control board.
3.2 Main Tab
1. Motor frequency display for Inverters. Utility for Converters.
2. Fault icon – Illuminated only during a fault.
3. Alarm icon – Illuminated only during an alarm.
4. Status icons – Four Status Icons are available as indicated in Section 2.3.
5. Inverter Speed Reference in percent. The display indicates a negative Speed Reference when in
reverse. For converters this display is DC voltage feedback.
6. Inverter local/remote mode status indication.
7. Motor rotation direction indication.
3.3 Status Icons
1. Not ready icon.
2. Ready and not running (stopped).
3. Ready and running forward.
4. Ready and running reverse.
1
2 3 4
5
6 7
1
2
3
4
To Next Page
Loading...
