2. Setting-Up OPC Server
10
<10> DCOM setting is completed.
Click < OK >.
<11>When installation type that selected "Both" or
"Server" in <6>, an inquiry starting Log Save
Tool processing automatically is displayed.
* : Log Save Tool function added in V01.40.
<12>Installation is completed.
Click <Finish>.
Figure 2.1 Install OPC Server
.
2.2. Maintenance
There are the modification (the change of the installation type) and the revision (a reinstallation and version
up) for maintenance.
Important:
Disconnect from the clients before modifying or repairing.
2.2.1. Modify
The way to change installation type is described below.
<1>Launch “Setup.exe” under in CD.
Input Serial numbers and click <Run>.
To Next Page
Loading...
