EasyManuals Logo

Toshiba TOSDIC-CIE DS Manual

Toshiba TOSDIC-CIE DS
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Appendix2. The diffrence between DPCS and DPCS Emulator
53
name on the engineering tools is “Analog input”, “Analog output (Current, Pusle, Voltage)”, please
register as block number 1 to 4 in order. Input the value of a place of SSIF module to a bus number and a
unit number. Input receiving / transmitting block number of SSIF1 to a module number. (The receiving
block 0 and the transmitting block 0 are not used.) Input the position in a block to a point number. (It
inputs from 1 to 26 that is the word position.)
About PVC Value at using SRT01 or STC01
You can check the PVC value on the Sensor Adjust Screen. But at the case of BIAS = 1 and LEVEL <>
0, the low input value is rounded off at 0%, because of the range conversion and sensor error. If you want
to see the value less than 0%, you set BIAS = 1 and LEVEL = 0, or BIAS = 0.
About registering Point parameters of I/O modules
"SIOs and DPCS cards do not match" alarm message will appear in system log, if the analog input
registration of VPCPX2 and point parameters of I/O modules are not equivalent.

Other manuals for Toshiba TOSDIC-CIE DS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba TOSDIC-CIE DS and is the answer not in the manual?

Toshiba TOSDIC-CIE DS Specifications

General IconGeneral
BrandToshiba
ModelTOSDIC-CIE DS
CategoryControl Systems
LanguageEnglish

Related product manuals