What to do if a serial bus error is detected in Toshiba Control Systems?
If a serial bus error is detected in your Toshiba Control Systems, recheck the wiring paths and ensure they are wired correctly. Also, connect the termination resistor correctly to the terminal section and tighten all screws securely. Finally, ensure that the numbers are set correctly.
What to do if an I/O bus error has been detected in Toshiba TOSDIC-CIE DS Control Systems?
If an I/O bus error has been detected, make sure the cable connector is fully inserted and locked in place. Connect the termination connector, and securely tighten the screws. Also, verify that the numbers are set correctly.
What to do if trouble is detected in the PI/O module external power supply of Toshiba Control Systems?
If trouble is detected in the PI/O module external power supply, connect it correctly and supply power to the relay unit. Secure the external wire and terminal block in place with screws. Ensure you are supplying the prescribed voltage.
What to do if a read-back error is detected in the analog output of Toshiba TOSDIC-CIE DS Control Systems?
If a read-back error is detected in the analog output, secure the external line terminal block with screws. Connect a load, check the polarity, and connect correctly. Apply a load of 0 to 750? when electricity is flowing.
How to fix distributor alarm indicator (SDA01) if it is lit in Toshiba TOSDIC-CIE DS?
If the distributor alarm indicator (SDA01) is lit, supply the rated power. Check the wiring and sensor where the excess current occurs.
General| Category | Control Systems |
|---|---|
| Manufacturer | Toshiba |
| Model | TOSDIC-CIE DS |
| Input Signals | Analog, Digital |
| Output Signals | Analog, Digital |
| Communication Interface | RS-232, RS-485 |
| Power Supply | 24V DC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
To Next Page
