Safety Precautions
vi
Avoid touching hot components:
Some components inside the modules become very hot after the power is turned on. To avoid
burns, do not touch them.
CAUTION
Do not touch components:
Do not touch pins, connectors or soldered surfaces in modules with any part of your body. Static
electricity may damage IC's or LSI's and cause equipment to fail. Also the pointed end of
component lead may hurt your body.
Do not disassemble the equipment:
Do not disassemble or modify the equipment or modules. Doing so may lesson equipment safety
or result in equipment malfunction or failure.
Handle cords and cables properly:
Do not force to pull, twist or bend cords and cables of power supply. Otherwise cables may break
or become hot.
Be careful of operations when the system is running:
Do not change function settings of switches on modules while the equipment is running.
Otherwise equipment may malfunction or fail.
Keep off metals:
Keep metals such as paper clips from going into the openings in the modules, units, and drives,
among others. Otherwise fire may result.
To Next Page
Loading...
Need help?
General
