Toshiba V Series - Initialization Sample Program

6F8C0904 57
4.9 Initialization Sample Program
4
4.9 Initialization Sample Program
This section describes the sample program that puts the EN311 into a run mode. After
the EN311 enters the run mode, it becomes possible to use the slave station functions of
the computer link/PC link.
Sample program specification: EN311 is installed into Slot 6 on the base.
Local IP address: 133.113.90.10
Local message transfer UDP port number: 2000
Start
Read the station status
7EFFH on DPRAM(word address)
Run mode ?
(If the result of ANDing with
1000H is 1000H)
Issue the operating mode control
request(stand by)
Issue the reset request
Issue the parameter setup request
Issue the operating mode control
request(run)
Read the station status
Requested operating mode?
End
Ｙ
Ｙ
Ｎ
Ｎ