Toshiba Vm Series - Applying State Change Notification Settings; Downloading and Verifying Notification Data

Chapter 3 Setting
6F8C1637
36
Download the registered data to the TB.
After checking the data, download it to the TNB module.
To download, display the parameter information, and select [File (F)]-
>[Download (D)].
Restart.
Restart the controller to make download content effective.
.
Check the registered data.
After the download, display the state change notification parameter screen
again, and select [View] -> [Tools and Modules] to confirm that the
information of TNB module can be read.
Figure 3-23 An example of reading the state change notification information
According to an example of table 3-23, “point No.2” in [Tool] moves up to “point
No.1” in [Module], because “point No.1” is registered “No”.
Then, GET_IP_INF command outputs “point No.1”.
Storage table in GET_IP_INF command.
Storage table
GET_IP_INF
Position Move up