TOTAL FLEX L - Assembling the Total Flex L; Power Pod Assembly

D. Assembling the Total Flex™ L
The Total Flex™ L comes almost fully assembled with the exception of one Power
Pod that requires attachment to the side of the Power Pod Seat.
Power Pod Assembly
1. Please follow the steps under Section E in order to fully open up your Total Flex™ L.
Begin the assembly of the Power Pod after step 5 in Section E.
2. Align the curved brackets of the Power Pod with the two holes in the square tube
underneath the Power Pod Seat. See 1 below.
3. Use the 2 bolts with spring washers and the Allen wrench provided with the unit to
securely fasten the brackets to the square tubing. See 2 & 3 below.
Note: If you have purchased the Leg Extender (available as an optional item),
additional assembly is required – see below.
Receptor Tube Assembly (Optional Item)
To assemble the Receptor Tube, fit the following parts to the Total Flex™ L:
1. With the Total Flex™ L in the open position (see Section E below: Setting up the
Total Flex™ L on page 7), adjust the Power Pod Seat to setting 5.
2. Hold the Receptor Tube (see 2 below) and align with the four holes
on the underside of the Power Pod Seat (see 3 below). Use the 4 bolts and the
Allen wrench provided with the unit to securely fasten the Receptor Tube to the
Power Pod Seat (see 4 below).
1 2 3
1 2 3 4
4