TP-Link Auranet EAP110 User Manual

Chapter 4 Network
On
Network
page you can configure the IP address of the standalone EAP.
Figure 4-1 Network Page
Dynamic/Static:
By default, the EAP device obtains an IP address from a DHCP server
(typically a router). Select Static to configure IP address manually.
Fallback IP:
If the EAP fails to get a dynamic IP address from a DHCP server within
ten seconds, the fallback IP will work as the IP address of the device.
After that, however, the device will keep trying to obtain an IP address
from the DHCP server until it succeeds.
DHCP Fallback
IP/IP MASK:
Enter the fallback IP/IP mask.
DHCP Fallback
Gateway:
Enter the fallback gateway.
5

TP-Link Auranet EAP110 Specifications

General

Band Technology	dual
Frequency Band	2.4 ghz
QoS Traffic Prioritization	yes
Ethernet Standard	10/100
Wireless Networking Standard	wi-fi 4
Wireless Standard	n
2.4 Ghz Streams	1
5.0 Ghz Streams	0
Gigabit Ethernet Speed	no
Antennas	2
Firewall	other
Data Encryption	yes
Encryption Type	wep, wpa, wpa-psk, wpa2-enterprise, wpa2-psk
Security Features	rogue ap detection; ssid to vlan mapping; 802.1x supplicant
Ports	rj-45
WAN Ports	1
Built In Modem	no
Bluetooth	no
System Requirements	microsoft windows 10/8/7/vista/xp

Weight and Dimensions

Height	1.9 inches
Width	7.1 inches
Net Weight	2 pounds