Channel:
Select the channel used by
this device to improve wireless
performance. 1/2412MHz means the Channel is 1 and the frequency is
2412MHz. By default, channel is automatically selected.
Tx power: Enter the transmit power value.
If the maximum transmit power is set to be larger than local regulation
allows, the maximum Tx power regulated will be applied in actual
situation.
In most cases, it is unnecessary to select maximum transmit
power. Selecting larger transmit power than needed may cause
interference to neighborhood. Also it consumes more power and will
reduce longevity of the device. Select a certain transmit power is
enough to achieve the best performance.
5.1.2 SSIDs
SSIDs can work together with switches supporting 802.1Q VLAN. The EAP can build up
to eight virtual wireless networks per radio for users to access. At the same time, it adds
different VLAN tags to the clients which connect to the corresponding wireless network.
It supports maximum 8 VLANs per radio. The clients in different VLAN cannot directly
communicate with each other.
Clients connected to the device via cable do not belong to any VLAN. Thus wired client
can communicate with all the wireless clients despite the VLAN settings.
Click in the Modify column, the following content will be shown.
Figure 5-4 SSIDs
9
To Next Page
Loading...
