LAN Port:
Displays the maximum transmission rate and duplex mode (half-duplex
or full-duplex) of the port.
Client
Figure 6-6 Client
MAC: Displays the MAC address of the client of the AP selected in AP List.
SSID: Displays the SSID the client is connected to.
SNR(dB):
Signal to Noise Ratio, the power ratio between the received wireless signal
strength and the environmental noise strength. The bigger the value of SNR
is, the better network performance the device provides.
CCQ(%):
Displays the wireless Client Connection Quality (CCQ). CCQ refers to the
ratio of current effective transmission bandwidth and the theoretically
maximum available bandwidth. CCQ reflects the actual link condition.
Rate(Mbps): Displays the data rate at which the client transmits wireless packets.
Down(Byte): Displays the throughput of the downstream data.
Displays the throughput of the upstream data.
Active Time: Displays the amount of time the client has been connected to the device.
LAN Traffic
Click LAN Traffic and you can monitor the data transmission status of the LAN port.
Figure 6-7 LAN Traffic
42
To Next Page
Loading...
