52
Chapter 6
Customize Your Network Settings
6. 1. 3. Reserve LAN IP Addresses
You can view and add a reserved address for a client. When you specify an IP address
for a device on the LAN, that device will always receive the same IP address each time
when it accesses the DHCP server. If there are some devices in the LAN that require
permanent IP addresses, please configure Address Reservation on the mesh device
for the purpose.
Follow the steps below to reserve an IP address for your devices.
1. Visit http://tplinkwifi.net or http://192.168.88.1, and log in with the password you
set for the mesh device.
2. Go to Advanced > Network > LAN Settings page, and select IPv4.
3. Scroll down to the Address Reservation section, and click Add to add an address
reservation entry for your device.
4. Enter the MAC Address of the device for which you want to reserve IP address.
5. Specify the IP address which will be reserved by the mesh device.
6. Select the Enable This Entry check box and click OK to make the settings effective.
6. 2. Configure IPv6 LAN Settings
Based on the IPv6 protocol, the mesh device provides two ways to assign IPv6 LAN
addresses:
• Configure the RADVD (Mesh Device Advertisement Daemon) address type
• Configure the DHCPv6 Server address type
To Next Page
Loading...
