User Guide 634
Configuring IPv4 IMPB IP-MAC Binding Configuration
Choose the menu SECURITY > IPv4 IMPB > IP-MAC Binding > ARP Scanning to load the
following page.
Figure 2-2 ARP Scanning
Follow these steps to configure IP-MAC Binding via ARP scanning:
1) In the Scanning Option section, specify an IP address range and a VLAN ID. Then click
Scan to scan the entries in the specified IP address range and VLAN.
Starting IP
Address/Ending
IP Address
Specify an IP range by entering a start and end IP address.
VLAN ID Specify a VLAN ID.
2) In the Scanning Result section, select one or more entries and configure the relevant
parameters. Then click Bind.
Host Name Enter a host name for identification.
IP Address Displays the IP address.
MAC Address Displays the MAC address.
VLAN ID Displays the VLAN ID.
Port Displays the port number.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
