The following entries are displayed on this screen:
Global Config
MLD Snooping: Enable or disable MLD Snooping function globally.
Report Message
Suppression:
Enable or disable Report Message Suppression function globally.
If this function is enabled, the first Report Message from the
listener will forward to the router ports while the subsequent
Report Message from the group will be suppressed to reduce the
MLD traffic in the network.
Unknown Multicast
Filter:
Choose to forward or drop unknown multicast data.
Unknown IPv6 multicast packets refer to those packets without
corresponding forwarding entries in the IPv6 multicast table:
When unknown multicast filter is enabled, the switch will discard
all received unknown IPv6 multicast packets;
When unknown multicast filer is disabled, all unknown IPv6
multicast packets are flooded in the ingress VLAN.
Router Port Aging
Time:
Enter the global router port aging time. If the router port does not
receive Query Message in the aging time, it will be aged.
Member Port Aging
Time:
Enter the global member port aging time. If the member port
does not receive Report Message in the aging time, it will be
aged.
Last Listener Query
Interval:
Enter the Last Listener Query interval time. When the multicast
group has no more member ports, it will send the Specific Query
Message with this interval time to check whether there is another
listener.
Last Listener Query
Count:
Enter the Last Listener Query numbers. When the multicast
group has no more member ports, it will send this numbers of
Specific Query Message to check whether there is another
listener.
124
To Next Page
Loading...
