Filter ID: Enter the Filter ID which identifies the
filter.
Start Multicast IP: Enter the start of the IP range.
End Multicast IP: Enter the end of the IP range.
Filter List
Select: Select the filter ID you want to change.
Filter ID: Displays the filter ID number.
Start Multicast IP: Displays the start of the IP range.
End Multicast IP: Displays the end of the IP range.
Note:
The max number of filter entries is 30.
8.2.4 Port Config
On this page you can configure MLD Snooping function with each single port.
Choose the menu Multicast→MLD Snooping→Port Config to load the following page.
The following entries are displayed on this screen:
Port Config
Select:
Select the port you want to configure.
Port: Displays the port number.
Filter: Choose to enable or disable filter function in this port.
Filter Mode: Choose the filter action mode. You can accept or
refuse Report message with specific multicast groups
specify by the filter IDs.
127
To Next Page
Loading...
