Filter IDs: Enter the filt
er IDs with this port. The filter IDs are
configured in Filer Config. The format is 1,4,12.
Max Groups: Enter the maximum groups which the port can join as
the member port. It ranges from 0 to 256.
LAG: Displays the LAG number.
Note:
1. If the Max Groups value is set less than the current value, some groups may be deleted to
satisfy the restriction.
2. The max number of filter entries on each port is 15.
8.2.5 Static Multicast
On this page you can configure static multicast groups. The multicast groups configured here are
not learned by MLD Snooping and independent of dynamic multicast groups and multicast filters.
The static multicast member ports won’t age out.
Choose the menu Multicast→MLD Snooping→Static Multicast to load the following page.
The following entries are displayed on this screen:
Static Multicast Config
VLAN ID: Enter the VLAN ID.
Multicast IP: Enter the multicast IP address.
Member Ports: Enter the member ports of the static multicast group.
Static Multicast List
Select: Select the static multicast group you want to change.
VLAN ID: Displays the VLAN ID.
Multicast IP: Displays the multicast group IP address.
Member Ports: Displays the member ports of the static multicast
group.
8.2.6 Querier Config
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
128
To Next Page
Loading...
