8
Disconnect all wires from the old switch, and connect them to the
smart switch as below. Check that all the wires are correct. Pull
gently to make sure each wire is secure.
Step 6. Remove Old Switch
1) Turn on your light switch, turn o your fan switch, and turn on the
circuit breaker to see that your light is working.
2) Use a voltage detector to identify the energized wire among the
two load wires. This should be the load wire of your light switch.
3) Turn o the circuit breaker and the light switch. Label the
energized wire as Lighting Load. Then label the other one as Fan
Load.
Step 5. Identify the Load Wires
To Next Page
Loading...
