39
Reboot: Click Reboot and then click Reboot on the pop-up screen to confirm. The reboot
will not change the camera’s setting. After rebooting, you need to log in to this page again.
Backup: Click Backup and follow the instructions on the browser to save the setting data
file to your specified location.
Browse: Click Browse to locate the saved backup file.
Restore: Click Restore, and then the camera will start rebooting. The settings will be
restored to the previous configuration.
Reset: Click Reset to restore the camera to its factory defaults. Don't turn off the camera
while resetting. After resetting, you need to add the camera to your TP-Link ID again, find
out the IP address of your camera (refer to 4.1 Log in to Your Camera
), and then use the
default username and password (admin/admin) to log in to this web management page.
Browse: Click Browse to locate the saved upgrade file.
Update: Before update, download the latest firmware from the product page at
http://www.tp-link.com
, and then use decompression software to extract the file. Click
Browse and select the downloaded firmware upgrade file. Then click Upgrade to update
the camera’s software to the latest version. Wait for the upgrading process to complete,
and the camera will reboot automatically.
To Next Page
Loading...
