TP-Link NC260 - Basic LED Indicator Control

NC260
18
2. To add a camera to your TP-Link ID, make sure that the camera is connected to the
internet.
Add Your Camera to TP-Link ID
If you already have a TP-Link ID, to add your camera to your account, just enter the TP-Link ID
and password, and then click Register.
 Account: Enter your TP-Link ID. Either E-mail address or username is allowed.
 Password: Enter your TP-Link ID’s password.
 Camera Name: The default value is the camera model. You can change it to an
easy-to-remember one. Camera name can contain up to 31 characters. It cannot contain
the following characters: \ / : = & ‘ “ < > { }.
After your camera is registered successfully, you can go to http://www.tplinkcloud.com
to view
it.
4.3.5 Basic > LED
The camera’s LED is on by default. If you want to turn it off, select Off and click Save.