TP-Link NC260 - System Log and Event Review

NC260
40

Note:
The firmware upgrade procedure must not be interrupted, or the camera may be damaged.
When upgrading firmware, do not unplug the camera or your computer, or close the web
management page until the process is complete.
4.5.4 System Log
On this page, you can review any changes and events happened to your camera. The system
starts logging automatically after startup.
 Time: Displays the time when the log event occurs. The log can get the correct time after
you configure on the Date/Time page. (Go to Advanced > Date/Time)
 Module: Displays the module to which the log information belongs. You can specify the
module by selecting one from the Module drop-down list at the bottom.
 Level: Displays the severity level of the log information. You can specify the level by
selecting one from the Level drop-down list at the bottom.
 Content: Displays the details of the log information.
 Refresh: Click Refresh to refresh the log information.
 Save Log: You may be asked to use this function when contacting our technical support for
troubleshooting.
 Clear: Click Clear to clear all the log information.
 Log Control: You may be asked to use this function when contacting our technical support
for troubleshooting.