TP-Link Omada EAP620 HD User Manual

98
1 Install Omada App on the Mobile Device
Omada app runs on iOS and Android devices, such as smart phones and tablets. Launch
the Apple App Store (iOS) or Google Play store (Android) and search “TP-Link Omada” or
simply scan the QR code to download and install the app.
Scan for Omada App Download Omada App
or
2 Manage and Monitor your EAP Device
For a relatively small-scale network which has a few EAPs (usually less than three) and only
basic functions are required, managing your EAPs via Omada app is recommended. You
can use a mobile device to configure each EAP individually for basic functionality.
Refer to the topology below, make sure that the following requirements have been met:
• An Ethernet connection from your Omada EAP to the LAN with DHCP service.
• Omada app is only compatible with certain firmware versions of the EAP. To check
the firmware versions of the supported EAPs, please refer to
https://www.tp-link.com/
omada_compatibility_list
.
• A compatible iOS or Android device with Omada app.
Internet
EAP
Router
EAP
Mobile Device Installed
with Omada App
Follow the steps below to manage your network via Omada app in standalone mode. The
following page is exampled with the iOS version of the app. The Android version is similar.

TP-Link Omada EAP620 HD Specifications

General

Frequency	2.4 GHz and 5 GHz
Antenna Type	Internal
PoE Support	802.3at PoE+
Maximum Power Consumption	12.5 W
Operating Humidity	10% to 90% non-condensing
Wireless Standards	IEEE 802.11ax/ac/n/g/b/a
Ethernet Ports	1 x Gigabit Ethernet (RJ-45) Port
Mounting	Ceiling/Wall Mounting
Wireless Functions	MU-MIMO, Band Steering, Load Balance, Airtime Fairness, Beamforming
Wireless Security	WPA, WPA2, WPA3
Management	Omada SDN
Antennas	4 × Internal Antennas
Operating Temperature	-30°C to 60°C (-22°F to 140°F)