3. 1. Check Internet Status
You can view the Internet status of your extender to check whether you have successfully
set up the extended network(s).
1. Visit http://tplinkrepeater.net, and log in with the username and password you set for
the extender.
2. Go to Settings > Status to view the Internet status of your extender.
The extender runs normally.
The extender fails to connect to the host networks. Please run the Quick Setup again.
The extender is connected to the host networks, but there are no transmitting data.
Please check the Internet connection of your router.
The extender is connected to the router abnormally. Maybe the gateway is set incorrectly
in the Static IP. Please set your computer to obtain an IP address automatically.
Click the icon of the Internet/Router/Range Extender/Clients to view corresponding
information.
3. 2. Configure Wireless Network
If you want to extend another host network after Quick Setup, you can refer to this
section. Moreover, you can change the wireless settings for your extended networks.
Visit http://tplinkwifi.net, and log in with the username and password you set for the
extender.
To Next Page
Loading...
