Omada Stackable L3 Managed Switch
06 Introduction
Management Port
Designed to connnect the device for management through web, CLI or SNMP.
Console Port
Designed to connect with a computer for monitoring and conguring the switch. When the switch has an
RJ45 console port and a Type-C console port, console input is active on only one console port at a time.
By default, the Type-C connector takes priority over the RJ45 connector, or you can change the priority
through the web.
USB Port
Designed to install the USB ash disk for data storage.
10/100/1000 Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100 Mbps or 1000 Mbps. For PoE
switches, the port can also provide power for PDs.
SFP+ Slot
Designed to install the 10 Gbps/1 Gbps optical module.
SFP28 Slot
Designed to install the 25 Gbps/10 Gbps/1 Gbps optical module.
Port Feature
Model
10/100/1000 Mbps
RJ45 Port
SFP+ Slot SFP28 Slot Management Port Console Port USB Port
SG6428X 24 4 / 1 2 2
SG6428XHP 24 4 / 1 2 2
SG6654X 48 6 / 1 2 2
SG6654XHP 48 6 / 1 2 2
SX6632YF / 26 6 1 2 2
■
Rear Panel
The rear panel of SG6428X/SG6654X is shown as the following figure. The figure is for demonstration
purposes only. Your switch may differ in appearance from the depicted.
Note:
PWR1 is the primary power supply and it takes priority over PWR2.
Kensington
Security Slot
Grounding Terminal Power Socket
To Next Page
Loading...
