Omada Stackable L3 Managed Switch
19Connection
Chapter 3 Connection
3.1 Ethernet Port
Connect an Ethernet port of the switch to the computer by RJ45 cable as the following figure shows.
Figure 3-1 Connecting the RJ45 Port
RJ45 Port
RJ45 Cable
3.2 SFP+/SFP28 Slot
The following figure demonstrates the connection of SFP+/SFP28 slot to an optical module.
Figure 3-2 Inserting the SFP/SFP+ Module
SFP+/SFP28 Slot
Optical Module
3.3 Console Port
CLI (Command Line Interface) enables you to manage the switch, thus you can load the CLI after
connecting the PCs or Terminals to the console port on the switch via a cable (an RJ45 console cable
is provided, while Type-C cable is not provided).
To Next Page
Loading...
