-23-
Get IP Address by
Unicast:
The broadcast requirement may not be supported by a few ISPs.
Select this option if you can not get the IP address from your ISP
even with a normal network connection. This option is not required
generally.
Use the following DNS
Server:
Select this option to enter the DNS (Domain Name Server) address
manually.
Primary DNS:
Enter the IP address of your ISP’s Primary DNS (Domain Name
Server). If you are not clear, please consult your ISP.
Secondary DNS:
Optional. If a Secondary DNS Server address is available, enter it.
Upstream Bandwidth:
Specify the bandwidth for transmitting packets on the port.
Downstream
Bandwidth:
Specify the bandwidth for receiving packets on the port.
¾ Dynamic IP Status
Status:
Displays the status of obtaining an IP address from your ISP.
z “Disabled” indicates that the Dynamic IP connection type is not
applied.
z “Connecting” indicates that the Router is obtaining the IP
parameters from your ISP.
z “Connected” indicates that the Router has successfully
obtained the IP parameters from your ISP.
z “Disconnected” indicates that the IP address has been
manually released or the Router gets no response from your
ISP. Please check your network connection and consult your
ISP if this problem remains.
IP Address:
Displays the IP address assigned by your ISP.
Subnet Mask:
Displays the Subnet Mask assigned by your ISP.
Gateway Address:
Displays the Gateway Address assigned by your ISP.
To Next Page
Loading...
Need help?
General
