-78-
Policy:
Select a policy for the entry:
z Block: When this option is selected, the packets obeyed the rule
will not be allowed to pass through the Router.
z Allow: When this option is selected, the packets obeyed the rule
will be allowed to pass through the Router.
Service:
Select the service for the entry. Only the service belonging to the
specified service type is limited by the entry. For example, if you
select “Block” for Policy and only FTP for Service, the packets of other
service types can still pass through the Router. You can add new
service types on 4.6.4.4 Service.
Interface:
Select interface for the entry. The entry will take effect when the
interface to which the data is flowing is selected. WAN or LAN refers
to all the WAN or LAN interfaces.
Source:
Select the Source IP Range for the entries, including the following
three ways:
z IP/MASK: Enter an IP address or subnet mask. ("0.0.0.0/32"
means any IP).
z Group: Select a predefined group of users. You can set the group
on4.4.1 Group.
z ANY: means for any users.
Destination:
Select the Destination IP Range for the entries, including the following
two ways:
z IP/MASK: Enter an IP address or subnet mask. ("0.0.0.0/32"
means any IP is acceptable).
z ANY: means for any users.
Effective Time:
Specify the time for the entry to take effect.
Description:
Give a description for the entry.
Priority:
Select this option to specify the priority for the added entries. The
latest enabled entry will be displayed at the end of the list by default.
To Next Page
Loading...
Need help?
General
