69
7.3.2 Alarm sending
Set to send the mail with connection to the alarm detection by the built-in motion detection
function. Select On to send the image and audio file to HTTP server linked with the alarm
detection.
Alarm sending: Select On to set to send command with connection to the alarm detection.
¾ Alarm
z Motion detection: Click it for using Motion Detection function as a sensor. You can set
motion detection function on the motion detection function page.
9 Parameter: the parameter of CGI (defined in Setting → Advance → HTTP event →
General → URL) is from your target device. For example, move=down.
9 Message: message will show up in the form of Message = PTZ down. If your target
device didn’t support the parameter of message, you can’t see the message. So you
can just take the message as a note. For example: PTZ down.
To Next Page
Loading...
