5
Bridge Mode
Operation Mode Setting
Click Wireless Mode
To choose the Operation
Mode, please click Wireless
Choose the Operation Mode
appropriate to your needs.
If Access Point mode is selected,
please proceed to part A;
If Repeater M
please skip to part B;
If Client mode is selec
skip to part C;
If Bridge m
please skip to part D.
ode is selected,
ted, please
ode is selected,
Note
If the wireless security is required, please refer to the Appendix A: Wireless
Security Setup to configure the Access Point after finishing the following
operation mode settings.
In this mode, the Access Point can wirelessly connect two or more remote LANs
together.
To Next Page
Loading...
