T1. How do I restore my Access Point’s configuration to its factory default settings?
With the Access Point powered
on, press and hold the Reset
button on the rear panel for 8 to 10
seconds before releasing it.
9
Hold it in for 8 to
10 seconds
Once the Access Point is reset, the current configuration settings will be lost
and you will need to reconfigure the router.
Note
T2. What can I do if I forget my password?
1) Restore the Access Point’s configuration to its factory default settings. If you
don’t know how to do that, please refer to previous section T1;
2) Use the default user name and password: admin, admin;
3) Try to reconfigure your AP by following the instructions of this QIG.
T3. What can I do if I cannot access the web-based configuration page?
For Windows XP OS
1) Go to Start > Settings > Control Panel > Network and Internet Connections
> Network Connections;
Right Click Local Area Connection or Wireless connection > Select
Properties;
2) Double Click Internet Protocol (TCP/IP) in the item list.
Select Use the following IP address, enter the 192.168.1.100 as the IP
address, 255.255.255.0 as the Subnet mask;
Select Use the following DNS server addresses, enter the DNS server
address provided by your ISP or network administrator;
3) Click OK button to finish the settings.
To Next Page
Loading...
